How do I wind the Bobbin on my Jade Machine?Updated 3 months ago

You have several ways to wind the bobbin on your Husqvarna Viking Jade machine that add to your creative enjoyment! 

Winding From Horizontal Position

1. Place the felt pad and thread spool on the spool pin in horizontal position. Slide on a spool cap of the right type and direction. 

2. Place the thread under the thread guide (A) from right to left. Pull the thread to the rear and around the thread guide (B) from left to right, then around thread guide (C) and into the notch (D). 

3. Pull thread to the right and then through the thread guide (E) from front to back. Pass thread under tension disc (F) in clockwise direction. Note: Make sure the thread is pulled securely inside the tension disc for correct thread tension. 

4. Thread through the hole in the empty bobbin (G) from the inside to the outside. 

5. Place the bobbin on the bobbin winder spindle. 

6. Push the bobbin spindle to the right to wind. A pop-up appears on the screen to inform you that bobbin winding is active. Press the foot control or the start/stop button to start winding the bobbin. Hold the end of the thread firmly when starting to wind. When the bobbin is full, release the foot control or press the start/stop button again to stop. Push the bobbin spindle to the left. The pop-up closes. Remove the bobbin and cut the thread using the bobbin thread cutter (H). 

JADE 35

JADE 20Note: When winding the bobbin from auxiliary spool pin, do not hook thread to the guide (C) and notch (D). 

Winding Through the Needle 

Make sure the presser foot is raised and the needle is in its highest position. 

Note: Use a metal presser foot when bobbin winding from the needle. 

Pull the thread from the needle under the presser foot and to the right through the thread guide (A). 

1. Thread through the hole in the empty bobbin (G) from the inside to the outside. 

2. Place the bobbin on the bobbin winder spindle. 

3. Push the bobbin spindle to the right to wind. A pop-up appears on the screen to inform you that bobbin winding is active. Press the foot control or the start/stop button to start winding the bobbin. Hold the end of the thread firmly when starting to wind. When the bobbin is full, release the foot control or press the start/stop button again to stop. Push the bobbin spindle to the left. The pop-up closes. Remove the bobbin and cut the thread using the bobbin thread cutter (H). 

JADE 35

JADE 20