How do I wind the bobbin on my Emerald, Onyx or E10/E20?Updated 3 months ago

Your Husqvarna Viking Sewing Machine has a simple bobbin winding system to add to your sewing enjoyment! 

Note: There may be slight differences in appearance of some items due to model.

1. Place the thread spool on the spool pin. Slide a spool cap firmly against the spool. 

2. Place the thread into the thread guide (A) from front to the back. ONXY Models ONLY

Bring the thread clockwise around the bobbin winding tension disc (B), making sure that the thread is pulled snuggly between the discs. 

3. Thread through the hole in the bobbin (C) from the inside to the outside. 

4. Place the bobbin on the bobbin winding spindle. Make sure the bobbin is pushed down firmly. 

5. Push the bobbin winding spindle to the right. Hold the thread end, and press the foot control to start winding. After a few turns, take your foot off the foot control to stop winding. Cut the excess thread tail above the bobbin, making sure to trim it close to the bobbin. Step on the foot control to resume winding. When the bobbin is full, the bobbin winding will slow down and stop automatically. 

6. Push the bobbin winding spindle to the left. Remove the bobbin and cut the thread.

Note: When the bobbin winding spindle is pushed to the right, the machine will not sew. Make sure to push the bobbin spindle back to the sewing position (left) before sewing.